I applied through a staffing agency. The process took 1 day. I interviewed at Customised Technologies (Bengaluru) in Jul 2016
Interview
i applied through elitmus. it was a test followed by technical interview and hr interview. it was 6 questions 30 minutes test. After the test they selected 4 out of approx 40 candidate. questions were not so tough but it was logical and time-taking. Some of the questions given below.
Interview questions [1]
Question 1
1. what is rectifier? How does it work ?
2. Number system-Base conversion.
I applied through university. The process took 1 day. I interviewed at Customised Technologies (Bilāspur, Chhattisgarh) in Sept 2016
Interview
The company visited our campus. There were two rounds, Written & Interview. Written contained 6 questions( Basics from geometry & electronics). Questions were of basic level and very not very tough. None of the questions related to embedded were asked in the written test. ( Questions could have been of more standard )
I applied through a staffing agency. The process took 1 day. I interviewed at Customised Technologies (Bengaluru) in Jul 2014
Interview
Written and Discussion round was there. In Written they ask some basic math and Electronics Question about resistor and Flowchart of a situation with solution.
They after the Written there is Discussion where Technical and HR will be at same Time. Discussion round was much easier you just have to convince them you are good enough.
Interview questions [1]
Question 1
About the Project and Basic Question on Electronics and Electrical. and little bit of basic C
